Chemical Resistant Traffic Paint Safety Grip Cold Anti Slip Cure Car Park Paint

Chemical Resistant Traffic Paint Safety Grip Cold Anti Slip Cure Car Park Paint

Use in unheated areas or outside during the winter months or whenever the temperature drops below 10°C.

1. Cures at 0°C 
2. Provides extra traction in areas of severe slip hazard, even when wet or oily 
3. Easily applied to concrete, stone, wood and flat steel 
4. Coarse anti slip finish 
5. Withstands constant foot and wheeled traffic 
6. Chemical resistant 
7. Applied as one coat 
8. Virtually solvent free 
9. Approved for use on sand and cement screed or concrete with under floor heating systems (up to 30°C surface temperature)

Cold Cure provides an attractive, coloured, fine aggregate textured finish which provides an anti slip surface for pedestrian traffic and a skid resistant surface for wheeled traffic.

The mineral aggregate finish is particularly suitable for hard wearing areas, making it an excellent choice for industrial flooring. Additionally it is resistant to spillages of a wide range of acids and alkalis (at 25°C) including:

Paraffin 
Fuel oils 
10% nitric, sulphuric and hydrochloric acids 
Sugar solutions 
Oxalic acid 
Citric acid 
Salt solutions 
Caustic soda 
Hypochlorite solutions 
Petrol alcohols

Coverage: approx. 5m² per pack. One coat is normally sufficient.

Specifications:

Appearance matt
Delivery Time (Days) standard
Primer Required no
Usage - Interior / Exterior interior or exterior
Usage - Properties will dry at low temperatures, heavy duty, coarse anti-slip finish, easily applied, chemical resistant, solvent free
Usage - Surfaces floor, ramps, steps
Max Operational Temp (deg C) 60
Application - Curing Time (hours) 24 at 10 degrees, 48 at 0 degrees
Application - Pot Time (hours) 0.5 at 5 degrees
Application - Recommended Coats 1
Coverage 5m² per pack

Surface Preparation:

Concrete:
Concrete to be treated must be at least four weeks old, completely dry and free of surface laitance (a weak dusty layer on concrete), contaminants and any previous poorly bonded coatings. All traces of grease or oil should be removed with Bio-D (or similar degreasant) and the area thoroughly washed off and allowed to dry. Very smooth concrete or concrete with surface laitance should be etched with Cemtetch to ensure adequate adhesion. The concrete should be thoroughly washed down and allowed to dry after treatment with Cemtetch.

Stone:
Stone should be dry and free of all loose surface material and contaminants.

Painted Surfaces:
Previously painted surfaces should be thoroughly abraded by sanding to improve adhesion and to remove any weak or loose material. A trial area is advisable to test compatability with previous coatings.

Bare Metal:
Remove any rust and flaking material by disc grinding or wire brushing. Apply the coating immediately after preparation to the clean metal surface. Grease or oil can be removed using Bio D a solvent free degreaser. Allow the metal to dry before coating.

Write a review

Note: HTML is not translated!
    Bad           Good

Chemical Resistant Traffic Paint Safety Grip Cold Anti Slip Cure Car Park Paint

  • Product Code: st82
  • Availability: In Stock
  • £201.47
  • Ex Tax: £167.89

Available Options