Epoxy High Build Floor Paint For Factories Warehouses And garages Anti Slip 4Ltrs
Reduce accidents in wet and oily areas. All the distinctive characteristics of the standard version plus the added advantage of excellent slip resistance
1. Anti Slip Gloss finish
2. High-build application gives excellent wear resistance
3. Protects the concrete from oil and chemical contamination
4. Non-tainting and virtually solvent-free
5. Easy to clean surface
Resistant to: Oil, solvents and harsh cleaning chemicals
Epoxicote High Build Anti Slip Rapid - Rapid Curing Safety Coating
A rapid curing version of Watco Epoxicote High Build Anti Slip which will help improve safety on wet or oily floors in only 4-6 hours. Ideal for areas where minimal downtime is required.
Epoxicote High Build Anti Slip Cold Cure - An anti slip version of our cold curing coating
A glossy, high build coating with an anti slip aggregate to reduce accidents. Designed for use in cold temperatures as low as 0°C.
Coverage: Approx. 18m² per 4L per coat
Appearance gloss Finish
Delivery Time (Days) standard
Primer Required very porous surfaces should be primed with Watco 4 Hour Epoxy Primer
Usage - Interior / Exterior interior
Usage - Suitable for factories, warehouses, garages and any areas where general chemicals may be spilt
Usage - Properties anti Slip
Usage - Surfaces concrete, wood or metal
Coverage (m² per litre/kg) 18m² per 4L per coat
Application - Curing Time (hours) Epoxicote High Build Anti Slip- 12 Hours at 15°C.......Epoxicote High Build Anti Slip Rapid - 4-6 hours at 15°C......Epoxicote High Build Cold Cure Anti Slip - Will take light traffic after 48 hours at 0°C
Application - Recommended Coats one coat is normally sufficient
How To Apply:
Decant all of the contents of the 2 inner tins into the outer tin, taking care to scrape out any sediment. Mix the components together very thoroughly using a spatula or similar wide bladed tool (a piece of wooden batten is ideal). Continue mixing until an even colour and consistency are obtained. Do not mix more than one unit at a time. If a paint stirrer fitted to an electric drill is used, also use the spatula to blend in any unmixed material from the sides and bottom of the tin.
Epoxicote High Build Anti Slip and High Build Anti Slip Rapid
Best results are obtained in warm conditions (minimum 15°C). On horizontal surfaces apply by medium pile type roller (not foam) in one coat. On vertical surfaces 2 thin coats are recommended.
Epoxicote High Build Cold Cure Anti Slip Epoxicote High Build Cold Cure Anti Slip shares the same application instructions as Epoxicote High Build Anti Slip, with the exception that best results are obtained between temperatures of 0°C and 10°C